New to labschool, taking an electronics in graduate school. Set up this circuit. The question read:
(b) Write a VI that calculates the voltage drop across R2 for all of the following:
R2=0, 50, 100, 200, 400, 800, 1600, and 3200 (other components values are as in (a)). Use
a for loop to calculate the value and build arrays for the voltage and R2 values. Make a graph
of them in your front panel.
(c) Calculate the voltage drop across R1 as R2 is varied as in (b). This can be done by modifying
the previous VI. Plot the voltage drop across R1 vs. R2 up to and including the case where
R2=3200.
This is for part c. I'm not getting any error messages, yet I'm not getting my output values! I did it on b and it worked. Not sure what the deal is. Any ideas?