Designing a self test program in labview of an attached hardware

Hi,

I'm a new user to labview. I am designing a tester to test a a particular equipment(power supply) using labVIEW 2009. I have successfully acquired and presented data on the Monitor screen  through Serial port.

I want to insert a self test routine in the LabVIEW that will always execute in the beginning before testing the equipment. This self test routine will check the credibility of hardware that is meant for checking the equipment.

The format of this self-test routine will be:

                                                                               1)  A dialog box or a pop-up window will be open that will display messages.

                                                                               2)  The format of messages displayed is shown in the attached file.

                                                                               3)  Each line is displayed one by one with  "Tick" at the start when volatges are     OK    

                                                                               4)  With "Cross" at the start when parameters are not OK.

Its just like an IC Tester. It starts its self test whenever u first switched on the Tester.

Can any one help me how to proceed.

Thanks