Hello,
I am posting the same VI with different issue here.
I have a tab control with 7 tabs, each containing a subpanel. When a tab control is selected I load and run the corresponding VI. Things work fine in LABVIEW.
But when I create the application, the behaviour becomes random. Sometimes couple of blank tabs show up, some times a single tab is blank. Closing ang re-running the main VI (the one with tab controls) sometimes loads the VI in previously blank tabs.
Is there something wrong with the VI?
Also, is there any way to debug while running the application?
I have double checked the paths and they point to correct address. I have also set all my subVIs to show front panel when called.
Attaching the VI. Ignore the 'frame 0' in the sequence.