Hello everyone:
I am new to the forum and also new to LabView. I have searched in the forum the question I will post and want to let people know in advance that I did not find any relevant/concrete answer.
I want to use LabView 2015 to read out data from an old HP 4145B Semiconductor Parameter Analyzer connected to a probe station. I also have a NI GPIB interface to make the link bewtween LabView and the HP 4145B.
I would like to know if there is any VI available for 2 terminal devices (in this case on wafer diodes) so that I can control directly the equipment from LabView and be able to read out the measured data directly from the HP4145 via LabView? The data I want to represent is IV curves.
Best regards and thanks in advance for your support,
George.