Hello,
I am a beginner in labview and I am trying to control a maxon motor and run a NIDAQ at the same time. Basically, I need to measure the pressures and the angles at the same time and record these.
The problem that I am facing is that when I execute the VI, the motor runs first and this is followed by the measurement. I have twiddled around with it a lot getting a lot of help from this community but I can't figure it out. No matter what I do the motor starts running first and after the motor has completed its movement then the DAQ takes the measurements.
Is there any way to run the motor and the sensors together? I can run the motor seperately and I can run the sensors separately in their own VIs but can't seem to run them sequentially.
Any help would be appreciated.
Aman