I have a wierd situation which I never have come across during my development of Xcontrols in LV.
I have a pretty complex Xcontrol which reacts slow to the user events. BUT When I have the block diagram open, and repeat the same events, it runs fast (normal). As soon as I close the block diagram of the Xcontrol, it goes back to slow motion mode. I tracked the events using Event Inspector and Xcontrol reacts slow to pretty much every event happening inside the Facade.
Again, it runs fast when I have the block diagram open. Can you let me know if you have come across this issue and possible causes for this? I have done the following so far:
1. Exited LV and reopened my project to exit out of any VI from highlighing the execution
2. Checked usiing the Event Inspector and made sure the events inside the facade is running slow
3. When I have the block diagram of the Xcontrol facade is open, it runs normal. As soon as I close the facade, its back to slow mode.