All,
I am working with an older SCC system with the following modules:
2@AI03
3@TC02
2@SG24
1@AI05
The orginal VI for this system used DAQ Assistant to configure each module individually, with different signal input range, scaled units, terminal configuration and custom scaling. See attached photos.
I am writing new code, but I don't generally use DAQ Assistant. Is there a way to configure each module individually without use DAQ Assistant? I have tried to configure the different modules directly, but I get "Resource not available" errors when I try to run the code.
Or should I just bit the bullet and use DAQ Assistant?
Thanks for any help.