Hello again all you helpful forum-goers!
I'm having some difficulties with a Hypervisor system seeing the two Pickering 6 channel programmable resistor cards that are loaded into the PXI chassis. When I boot into Windows mode, MAX sees them under the My System just fine. When I then run the Hypervisor configuration software, I see them both listed, and have them assigned to the Real-Time OS. However, when I then boot into Hypervisor mode, MAX does not see them under the Remote Systems -> Hypervisor Target -> Chassis (or anywhere else), and the drivers report not seeing any modules either when I debug my code running on the real-time system.
Does anyone have any idea what setting or configuration I might have incorrect? Is there any other information I can provide that would be relevant or useful to answer this question? I'm not the main hardware guy, he just got married and so isn't available, so I'm out of my comfort zone. ;-) I write the software that runs on the system, though, so I'm not completely clueless. I know we just replaced the controller in the main chassis with a faster one (unfortunately I don't have the number on hand, the simulator is down in the lab), but I also know we are using that same controller and Pickering card on a different simulator and it is working just fine.
Any ideas? I very much appreciate your time!
-Joe