I want to draw multiple lines on intnsity graph, as shown in attachment.
But I need the lines to fill all the graph, while I only draw few lines in the attachment.
The attachment is my data and the lines on it are drew by photoshop.
the lines are on the shadow area which represent the lattice direction.
And this link is the question I asked before with very good resolution by Altenbach, which is easier than this one.
http://forums.ni.com/t5/LabVIEW/drawing-lines-on-intensity-graph/m-p/2450058/highlight/true#M752585
And my requests are
1.set line1's angle, then draw on the graph
2.set the distence between each line and the area where lines will cover on it.
3.set line2 with all the steps as line1
4.line3 and so on.
Is there anyone can help or give any suggestion?