Hello,
I was attempting to connect a cDAQ-9178 with three NI 9860s installed and in NI MAX it maps some of the CAN interfaces as 'CAN-1' (see attachment) and does not give me the option to change the interface name. Usually there is no '-' in the name. I did have to update the firmware on these modules to match the version of XNET on the computer, but the problem persisted. I also attempted on a different computer with no issues. In MAX I went through 'Reset Configuration Data', which also did not solve the problem.
I had previously connected to many (100+) C-series CAN modules all of which had proper CAN interfaces.
My question is, did XNET run out of 'available' interface names?
Any ideas here?