Hi
I have a few question regarding the measurement of humidity using labview.
First of all I should say i'm a beginner and I am not too familiar with labview, but this is something that needs to be done.
I'm using a HIH4000 humidity sensor (3-wired) and a USB-6008 DAQ device.
The problem is that i'm not sure how to configure the DAQmx.read block in labview to be able to measure relative humidity.
I've measured temperature before (when configuring the read block, temperature one of the options to choose from, while there is no 'relative humidity' option).
That's about it, if you need more information i'll share it with you asap.
Thank you!