Activate switch issue

Hello,

I'm using Matrix module in my test setup.

Trying to switch signal_x to 24V using Matrix card c1->r0 and then after certain delay of 1 sec, would like to enable signal_y to 24V (c2->r0). when I perform second signal enabling both signal_x and signal_y should be at 24V.

But I'm facing a issue that the signal_x will be disconnected when I try to switch signal_y.

Can some one help, how can I program them so that both signal will be enabled with a delay as explained above.

c1=signal_x

c2=signal_y

c3=signal_z

r0=24V