V8.2.1 - Currently working on creating a control vi that will record current, voltage, temp data while a pump is on. After a pump is on for a bit the float switch on the pump will turn the pump off. The data only needs to be collected while the pump is running. I have it set up, I think, to only collect data when the current being drawn by the pump exceeds a set point control on the front panel.
Primarily - It will currently log data but I do not know why it is overwriting the data . I need it to just log data while the pump is running..
Secondarily, I also would like to figure out how to control the scan rate of collecting data better than just setting the ms timer