Welcome!
i would like to realize a motor controller in NI LabVIEW. I want to controll the motor between two optical sensors like limit switches. But I don' t know how can I controll it, because I am split a cube on an inclane. The first step is that I incrase the degree of the inclane and the cube is splitting down on it. But it goes in front of the first sensor and next to it goes in front of the second sensor. If the cube arrives the second sensor i want to activate the program, I want to pulling back the cube behind to the first sensor and stop the program. But because it goes twice in front of the first sensor I don't know how can I solve this problem in programming.