Hi-
I am running LabVIEW 2013 SP1f1, DAQmx 9.8 and NI Max 5.6 on a Win 7 32bit install and can not add the DAQ Assistant Express VI to the block diagram. So far I have:
- Repaired DAQmx
- Upgraded from 2013 to 2013 SP1
- Deleted DAQmx and reinstalled twice
- Deleted and reinstalled the drivers
- Updated to f1
I am completely stuck here... any advice? When I try to place an instance of DAQ Assistant LabVIEW hangs and becomes unrespoinsve requiring force quitting via the task manager.
Any help is greatly appreciated!