As stated, I ran updates yesterday through NI Update Service... it suggested SP1, and a couple of others. Ran them, and today my computer doesn't see my cDAQ (9174).
Running...
Win7 Pro 64bit
LabVIEW Professional Ver. 12.0.1f2 (32-bit)
MAX Ver. 5.4.0f0
Tried to run my VI I was working on day before... obviously, if it's not seeing the cDAQ then it can't get data... ran MAX and it still shows up on the list, but doesn't' register as being hooked up. I tried powering it down and back up, rebooted computer, restarted LabVIEW, unhooked the unit from the hub it's normally hooked to and retried everything above with it plugged directly into my laptop.... nada.
I'm at a bit of a loss here. Anyone have any suggestions? I'm going to take the laptop over to my other systems and see if it recognizes any of them.
Thanks!
Chad