Hello,
I am trying to run what I preceived to be a very simple VI. I am using a DAQ assistant connected to a NI9401 which is housed in an NI9188. Wired into this is a motor encoder. What I was trying to do was record the number of encoder signal pulses in order to calculate the speed. (2048 pulses per revolution)
I am running the system for 5 seconds max during the pre-testing stages but I am finding that the data being obtained is timed over 40 seconds. Can anyone advise me as to where I am going wrong? or a simpler/more effiecient way of obtaining these results.
Regards
Joshua