Hello,
Thank you to whomever is reading this. Can someone point me to an appopriate thread or explain how to set up an oscilloscope to interface with LabVIEW? So far I have looked through several threads because I do not like cluttering forums. I have never added a physical device to be read into LabVIEW so this is a new experience for me. I am using the following:
-LabVIEW 8.3
-VISA 5.3
-Prologix: GPIB-USB Controller
-HP 10833B GPIB cable
-Laptop with Windows 7: 32 bit
I am not sure how much of that informationis relevant, but I felt that "more is more" in this instance. Thank you again for taking the time to read this thread.