I configure 2 DAQS via USB hub at my desk (development PC) with all digital outputs, some open collector and some active using two DAQ Assistants, one for Daq1 and one for Daq2. I save the VI where they’re used.
I go into Max and rename Dev1 and Dev2 to 1875DAQ1 and 1875DAQ2 AND in attributes I associate their respective serial numbers, so they don’t get switched when plugged into another pc.
In Max I then Export settings to a file on our network.
I go to another PC and import these settings in MAX. Then connect the hub with the DAQs, and in Labview 2011 I open the VI and open the DAQ Assistant for each DAQ, and I get the error message shown below. Behind the error message I see the two tabs for Settings and Device. Device is where it shows the digital outputs as either OC or Active. When I click OK on the error message, the Device tab DISAPPEARS, so I can’t verify the configuration of my DAQ outputs as active or OC. Why am I getting this message?
Why can’t I view my DEVICE tab?
Image may be NSFW.
Clik here to view.
