Quantcast
Channel: LabVIEW topics
Viewing all articles
Browse latest Browse all 69527

Communicate between different LabVIEW executables

$
0
0

Hello all,

 

I would like to program a set of labview executables.

1 executable will be the main interface.

The other executable will be a driver for a sensor which we want to use.

 

In order for this to work, I would like for the executables to communicate with each other.

 

It is possible that we will need a configuration where we will connect more then 1 sensor to the interface.

My preference would be to use the same set of commands for this sensor.

I can the call a second instance of the same sensor driver executable.

 

The structure of this software would be like the structure shown in the diagram below:

AFromTheHays_0-1724398474043.png

 

I have tried to do this using "shared variables". This works incredibly for 1 sensor.

As far as my knowledge about shared variables stretches, it is quite hard to use the same set of commands for 2 different drivers.

It is not possible for shared variables to have something alike an address to make a distinction between one driver or the other.

 

I would like to ask this forum for your opinion on methods to program this.

This method does not specifically have to be based on shared variables, I am open to all advise.

I am using LabVIEW 2019.

 

Thanks in advance!

 

 


Viewing all articles
Browse latest Browse all 69527

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>