Hi
I have an XControl with a big event handler (about 20 events currently). When I run this XControl for debugging ("Run Continuously"), its frontpanel freezes after only a few clicks, sometimes even directly after start. When I set timeout in the event handler to a value greater than a few milliseconds, it works.
The event handler is built as described here: http://www.ni.com/white-paper/3198/en/
- Why does it crash when timeout is 0? Is this a normal behavior because the handler might take a few milliseconds to finish?
- Is it a good fix to just increase timeout to some 100 milliseconds or will I likely run into new problems?
Best regards,
Michael