I have a crio 9023 that is failing after installing any software to it. Attached is the console output:
cRIO-9023 Boot
Copyright 2008-2009 National Instruments Corporation
Bootrom version: 2.1.2f2
Creation date: Jan 7 2010, 16:07:25
f
Press any key to stop auto-boot...
1
0
auto-booting...
boot device : usbms
unit number : 0
processor number : 0
host name : lvrt
file name : /c/ni-rt/system/vxWorks
flags (f) : 0x8
Attaching to USB disk device...
USB mass storage firmware version: 1.0.0f2
Using SST NANDrive
Reliance File System Driver
Datalight Reliance v3.2.2 Build 1376BV
VxWorks Edition for ppc603
Copyright (c) 2003-2008 Datalight, Inc. All Rights Reserved Worldwide.
Loading /c/ni-rt/system/vxWorks...2885248
Starting at 0x10000...
USB mass storage firmware version: 1.0.0f2
USB disk /c þ
cRIO-9023 Boot
Copyright 2008-2009 National Instruments Corporation
Bootrom version: 2.1.2f2
Creation date: Jan 7 2010, 16:07:25
Press any key to stop auto-boot...
1
0
auto-booting...
boot device : usbms
unit number : 0
processor number : 0
host name : lvrt
file name : /c/ni-rt/system/vxWorks
flags (f) : 0x8
Attaching to USB disk device...
USB mass storage firmware version: 1.0.0f2
Using SST NANDrive
Reliance File System Driver
Datalight Reliance v3.2.2 Build 1376BV
VxWorks Edition for ppc603
Copyright (c) 2003-2008 Datalight, Inc. All Rights Reserved Worldwide.
Loading /c/ni-rt/system/vxWorks...2885248
Starting at 0x10000...
USB mass storage firmware version: 1.0.0f2
USB mass storage firmware version: 1.0.0f2
USB disk /c þ
(it reboots again after this point and starts over)
Any ideas what to do? The status LED3 is constantly lit (indicating critical error - contact NI).
I have reinnstalled, formatted etc etc etc but to no results. (safe mode works) All IP settings are OK. This is only happening to this controller, and the controller is new out of the box. As said, installing the same software to another 9023 controller gives no issues. (We have currently 8 other 9023's running the same software as well)